To exit programming mode pressįull access to programming, except access codes. Data will be saved auto- matically and the software advances to the next programming section. Values are programmed into memory locations from addressĬurrent value will be displayed on keypad.Ĭan be used to program sections 00 to 67.Įnter a 2-digit section number, followed by 8 digits to program that section (confirmation beep). ). Programmed values of all other addresses do not change.Īll digits from 0 to F are valid. Values entered at addressesĪs well as all user codes, will be erased ( (5) Remove jumper.įactory default installer and master codes will be reinstated. (2) Connect a jumper between "reset jumper" pins. (1) Remove battery and AC to power down the unit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |